Sand spikes push in. PVC pipe sits in.
Rod Anchor screws in.
That’s the difference.
Built for Peace of Mind.
Because you shouldn't have to watch your rod every second.
Wind shifts. Surf pulls. Big strikes happen fast.
We were tired of second-guessing our setup, adjusting, checking, hoping it would hold.
So we built a rod anchor that screws deep and stays put.
Less worrying. More fishing.
What makes it different
- Screw-In Stability
- Zero Wobble
- Deep Anchoring
- Wind Resistant
- Strike Ready
- Heavy-Duty
- Surf Tough
The Founders
Two Aussie Blokes
Andy & Craig are two lifelong mates who grew up fishing Australia’s coastline and set out to build gear that could handle the same conditions they’ve trusted their own memories to.
Finally. I've snapped two rods over the years from holders that just gave up in the wash. This thing didn't move once in a full day session at Fingal. Absolute weapon.
Mate threw one in as a gift and I thought it was a gimmick. Used it the next weekend at Noosa North Shore and I'm already ordering two more. Should've had this years ago.
Had a jewie smash the rod at 2am. Woke up to the rod still in the holder, fish still on. If that's not a review I don't know what is.
We do long beach sessions so we need gear that just works. Set it up, walked 200m down the beach, came back and it hadn't budged an inch. Sharon wants one for her setup now too.
Join 200+ verified buyers. Read all reviews →
Save more, fish more
Bundle & Save Big.
The bigger the bundle, the more you save.
Pause or cancel anytime — no strings attached.
Single
Rod Anchor GEN II
The anchor itself. Screws in, stays put. Everything you need to start.
- Rod Anchor GEN II
- Aussie flag sticker
- Removable pin
- Reflective tape
Add-On
Accessory Pack
Everything to make a full day session easier. Pairs perfectly with the Rod Anchor.
- Drink Can Holder
- Blade & Sheath Holder
- LED Torch & Pouch
Bundle
Rod Anchor + Accessory Pack
The full setup. Rod Anchor plus everything you need for a proper session.
- Rod Anchor GEN II
- Drink Can Holder
- Blade & Sheath Holder
- LED Torch & Pouch
- Sticker, pin & tape
Multi-Buy
Buy More, Save More
Grab one for the crew. The more you buy, the more everyone saves.
- Buy 2 — save 10%
- Buy 3 — save 15%
- Buy 4+ — save 20%
Multi-Buy Discounts — applies to Rod Anchor & Bundle
🛡️ 30 Day Money-Back Guarantee — Love it or we'll make it right. No drama.
Rod Anchor FAQs
How deep does the Rod Anchor screw into the sand?
Deep enough that it won't move, the screw end is 20 cm. Even in wet, loose surf sand. The screw design means the harder conditions get, the more it locks in.
Will it work in wet sand and surf conditions?
Yep that's exactly what it's built for. Most rod holders fail in wet sand because they just push in. Rod Anchor screws in, so surf wash and shifting sand actually works with it, not against it.
What if a big fish hits while I'm not watching?
Rod Anchor holds under serious strike pressure. It's not going anywhere, so neither is your rod.
Is it easy to remove when I want to move spots?
Just unscrew and go. Same motion as putting it in — a few twists and it's out. Takes seconds.
What makes it different from a regular sand spike?
Sand spikes push in. PVC pipe sits in. Rod Anchor screws in. That one difference is everything — it's the reason it's ute proof and they aren't.